• Feb 26, 2018 News!'Writing Tips' shared by Prof. Ian McAndrew!   [Click]
  • Mar 06, 2018 News!IJMMM Vol.6, No.4 has been published with online version. 15 peer reviewed articles are published in this issue.   [Click]
  • Dec 29, 2017 News!The submission for 2018 2nd European Conference on Materials, Mechatronics and Manufacturing was over on December 25, 2017.
General Information
    • ISSN: 1793-8198
    • Frequency: Quarterly
    • DOI: 10.18178/IJMMM
    • Editor-in-Chief: Prof. K. M. Gupta, Prof. Ian McAndrew
    • Executive Editor: Ms. Cherry L. Chen
    • Abstracting/Indexing: EI (INSPEC, IET), Chemical Abstracts Services (CAS),  ProQuest, Crossref, Ulrich's Periodicals Directory,  etc.
    • E-mail ijmmm@ejournal.net
Prof. Ian McAndrew
Embry Riddle Aeronautical University, UK.
It is my honor to be the editor-in-chief of IJMMM. I will do my best to help develop this journal better.

IJMMM 2014 Vol.2(3): 210-213 ISSN: 1793-8198
DOI: 10.7763/IJMMM.2014.V2.129

Experimental Cases in Aluminium Foils by Dieless Process and His Comparison with Others Conventional Sheet Metal Forming Process

Gabriel J. Paramo and Adrian J. Benitez
Abstract—Incremental sheet forming by the method of single point incremental forming Dieless, is a widely studied process, experimented and developed in countries with high manufacturing technologies, with friendly costs when the productive configuration in a productivity system is based in small production batches. Previously mentioned, this work pretends to develop experimental cases in aluminum foils with 1 mm- thickness, and some specific process parameters, the analysis of forming limit curve (FLC), with the objective to emphasizes in this innovative method based in CAD-CAM technologies, compare with other analogous process of deformation sheet metal like embossing, deep drawing, stamping, spinning, superforming, take correct decisions about the viability and applicability of this process (Dieless) in a particular industrial piece, which responses to the necessities of productive configurations mentioned and be highly taken like a manufacturing alternative to the others conventional process of forming sheet metal , for systems with slow batches production.

Index Terms—CAD-CAM, dieless, forming limit diagram curves (FLD), toolpath.

The authors are with the Manufacturing Department at EAFIT University, Medellin, Colombia (e-mail: {gparamo, abenite2}@eafit.edu.co).


Cite: Gabriel J. Paramo and Adrian J. Benitez, "Experimental Cases in Aluminium Foils by Dieless Process and His Comparison with Others Conventional Sheet Metal Forming Process," International Journal of Materials, Mechanics and Manufacturing vol. 2, no. 3, pp. 210-213, 2014.

Copyright © 2008-2018. International Journal of Materials, Mechanics and Manufacturing. All rights reserved.
E-mail: ijmmm@ejournal.net