HOME > Archive > 2014 > Volume 2 Number 4 (Nov. 2014) >
Volume 2 Number 4 (Nov. 2014)
Article# Article Title & Authors Page
139
Effect of Blade Exit Shape on Performance and Vibration of a Double Volute Centrifugal Pump
Atia E. Khalifa
 261
140
Monitoring of Biodiesel Transesterification Process Using Impedance Measurement
T. Rachmanto, D. Allanson, C. Matthews, and I. Jenkinson
 265
141
Optimization and Effect of Process Parameters on Tool Wear in Turning of Titanium Alloy under Different Machining Conditions
M. Venkata Ramana, G. Krishna Mohan Rao, and D. Hanumantha Rao
 272
142
Mathematical Modeling of Food Freezing in Air-Blast Freezer
Guiqiang Wang and Pinghua Zou
 278
143
Development of Autonomous Intelligent Vehicle (AIV) Based on Voting Technique
M. R. Ghazali, M. S. Isa, W. I. Ibrahim, and S. H. Mohamed Noor
 282
144
Development of Ecological Process Dry Cleaning to Wash Alpaca Fiber Garments
Zegarra A.
 286
145
Influence of the Double Cone Drill Geometry on the Holes Quality during Drilling Multi-Stack Made of CFRP/Al
R. Zitoune, N. Cadorin, B. S. Elambouacif, F. Collombet, V. Krishnaraj, and H. Bougherara
 292
146
Fluid Flow Analysis of a New Finned Piston Reciprocating Compressor Using Pneumatic Analogy
Mahbod Heidari and Alfred Rufer
 297
147
Flux Prediction in Direct Contact Membrane Distillation
Dahiru U. Lawal and Atia E. Khalifa
 302
148
Using Double Pressure Heat Recovery Steam Generator Equipped with Duct Burner for Full Repowering a Steam Power Plant and Its Analysis by Exergy Method
V. Rohani and M. Ahmadi
 309
149
Investigation of the Lattice Boltzmann SRT and MRT Stability for Lid Driven Cavity Flow
E. Aslan, I. Taymaz, and A. C. Benim
 317
150
Prediction of Buoyancy-Driven Flow in a Slot with Different Biot Numbers
Emel Selamet and Ahmet Selamet
 325
151
Study and Comparison of Inlet Air Cooling Technique of Gas Turbines and Their Effects on Increase of the Efficiency and Outlet Power
Seyed Ali Sakhaei and Mahbod Safari
 329
152
Study of the Influence of Process Parameters on Surface Roughness When Inconel 718 Is Dry Turned Using CBN Cutting Tool by Artificial Neural Network Approach
M. V. R. D. Prasad, Yelamanchili Sravya, and Karri Sai Tejaswi
 335
153
The Effect of the Width and Number of Gaps on the Characteristics of Swirl Flow Induced Naturally inside Split Channel Using Hot Air Inlet
Safia R. Al Atresh, Ahmad S. Sharifian, and Andrew P. Wandel
 339
Copyright © 2008-2020. International Journal of Materials, Mechanics and Manufacturing. All rights reserved.
E-mail: ijmmm@ejournal.net